Desktop Metal announced the launch of the all-new PureSinter Furnace for high-purity, one-run debinding and sintering of powder metal parts. PureSinter is compatible with powder metal parts 3D printed with Additive Manufacturing, such as Bound Metal Deposition (BMD) and Binder Jetting (BJT) processes, as well as traditional Metal Injection Molding (MIM) or Press and Sinter (PM) manufacturing methods. For decades, the powder metal manufacturing industry has been challenged by sintering furnaces that are easily contaminated by hydrocarbons and other waste emitted by powdered metal parts.

This contamination builds up on walls and other surfaces inside the furnace and causes undesirable chemical reactions and furnace reliability complications that have long challenged powder metal manufacturers. In development for more than five years, PureSinter reinvents furnace design from the ground up to eliminate traditional furnace challenges with an all-new, patent-pending approach. PureSinter features hot walls that prevent contamination buildup and an airtight processing environment to ensure efficient waste exit and the levels of purity.

PureSinter has undergone extensive testing and shows little to no contamination or buildup inside the furnace, even after hundreds of runs. Consequently, PureSinter delivers the quality sintered parts, on par or better than premium furnaces with higher acquisition, energy utilization, and operating costs. Even titanium can be easily sintered with a high degree of confidence without the complex preparations required with other furnaces.

PureSinter is Ti-Tested with excellent results. The PureSinter furnace is compatible with all of DM?s metal printer platforms and binders, and the system is currently validated with 14 metal powder and DM binder combinations, including stainless steels, tool steels, superalloys, and reactives. Additional material validations are in process.

PureSinter can reach a maximum temperature of 1,420°C and is qualified for use with a variety of processing gasses, including argon, nitrogen, forming gas, and air. The system also features a total of 17 fans and a pop-out ceiling vent for active, rapid, and consistent cooling as well as fast turnaround times. Importantly, PureSinter does not require cold walls with expensive water-cooling features.

As experienced furnace users know, cold walls are collection points for debinding residue and contaminants. With an oxygen-tight retort seal, and an efficient cooling system, the PureSinter energy requirements offer a dramatic improvement over other furnaces that it competes with on performance. The electrical requirements are 200-220V, 40A; 380-415V, 20A, 3ph, 50/60hZ.

With a maximum power draw of 15.2 kW, PureSinter has a holding steady state power draw of approximately 7 kW at 1420°C. PureSinter also modernizes the experience of operating a furnace, with a vertical furnace design that offers an efficient footprint, an automated thermal hood lift, touchscreen controls, and unparalleled visibility inside the retort. The Desktop Metal PureSinter Furnace, along with metal parts sintered in the PureSinter furnace, will be on display June 25-27 in Los Angeles at Rapid + TCT, North America?s additive manufacturing and industrial 3D printing event. Desktop Metal is located in Booth No.

2139 on the main promenade and will showcase a wide range of its AM 2.0 technologies for metal, polymers, and ceramics.