AMETEK, Inc. : Model 40 Pneumatic Controller Meets NSPS Quad "O" Performance Standards for Oil and Gas
January 30, 2014 at 07:37 pm IST
By
Share
Release Date: Thursday, January 30, 2014
CONTACT: Tom Guinn (215-354-1832)
FEASTERVILLE, PA-The Model 40 Pneumatic Indicating Controller from AMETEK PMT Products complies with EPA's "Go Green" Initiative under the new Clean Air Act Standards. The Model 40 meets the QUAD "O" standards' requirement of an exhaust rate not to exceed 6.0 standard cubic feet per hour.
The versatile and environmentally friendly Model 40 is designed to sense pressure and transmit an air signal, which is precisely proportional to the measured variable. The output signal from its transmitter can be fed to a valve positioner or other remotely located final control device.
The Model 40 offers the safety of a fully pneumatic device, while reducing both operating cost and environmental impact, limiting fugitive emissions when operating on natural gas. In addition, the device provides the convenient operation of a single low-bleed controller with a high-capacity relay that will provide process indication even in the event of a loss of power or air supply.
The Model 40 pneumatic controllers are able to automatically position a valve or other final control element to maintain process pressure at a desired set point. It features broad selection of control modes (proportional, proportional plus reset (P+I), proportional+reset+rate (PID), and differential gap as well as a large, easy-to-read black on white dial for maximum resolution.
The Model 40 offers flexibility, accuracy and dependability. It is able to operate for extended periods in inaccessible locales without attention and has a wide selection of process measuring elements available for pressure, differential pressure, flow and level. Its accuracy is within +/-1% of full scale of indication and +/- 0.5% is available on most ranges.
As a receiving controller, it can control any process variable transmitted as a pneumatic signal. Its transmitters are designed in appearance to match the indicating pneumatic controller. The transmitters measure many different variables and provide standard 3-15 psi output, 100% linear to the process measurement range.
AMETEK PMT Products is a unit of AMETEK, Inc., a leading global manufacturer of electronic instruments and electromechanical devices with annual sales of $3.6 billion. For more information, contact AMETEK PMT Products, 820 Pennsylvania Blvd., Feasterville, PA 19053 USA. Phone: 215-355-6900. Fax: 215-355-2937. Web site: www.ametekusg.com
Click here for a hi-res image of the AMETEK PMT Model 40 Pneumatic Indicating Controller
AMETEK, Inc. is one of the world's leaders in manufacturing and marketing electronic instruments and electromechanical devices. Net sales break down by family of products as follows:
- electronic instruments (70.1%): instruments and screens for aircrafts cockpits, airborne electronic systems of data surveillance and registering, pressure, temperature and flow sensors for airline companies and aeronautical manufacturers, analysis devices for the medical and research sectors, measurement and surveillance instruments used in the processing industries, instruments and dashboards for heavy trucks and agricultural vehicles, etc.;
- electromechanical devices (29.9%): brushless motors, heat exchangers, connectors, terminals, thermal management subsystems, motors-blowers, etc. primarily for the aeronautic, automotive, medical, computing and defense sectors. The group also provides metal powders and alloys for the manufacturing of electronic components and automotive and aeronautic products.
At the end of 2023, the group had more than 150 production sites worldwide.
Net sales are distributed geographically as follows: United States (52.6%), Asia (20.9%), United Kingdom (3.3%), European Union (14.3%) and others (8.9%).